John Deere 318 - Manual (Page 128)

2. Remove four snap rings (A).
M43748
-UN
-12JAN90
3. Remove cross and bearing assembly using soft metal
rod. Push bearing down until it can be removed.
4. Turn cross and bearing assembly over. Push down
until bearing can be removed.
5. Separate end yoke from splined yoke.
M43739
-UN
-12JAN90
6. Remove cross and bearing assembly using a soft
metal rod. Push bearing down until bottom bearing can
be removed.
7. Remove cross and top bearing.
Clamping-Yoke Shown
M36591
-UN
-25JAN90
ASSEMBLE DRIVE SHAFT
IMPORTANT: Be careful not to damage needle rollers
and seal while installing cross and
bearing assembly.
1. Install cross and bearing assembly using soft-faced
hammer or press. Push bearing down until snap ring
groove is inside end yoke.
M43752
-UN
-12JAN90
M21,5025K,8 -19-08SEP86
M21,5025K,9 -19-17SEP86
MX,15905025,4 -19-07MAR95
MX,15905025,8 -19-20MAR95
Drive Shaft/Assemble
TM1590 (17MAY95)
50-25-4
316, 318 & 420 Lawn and Garden Tractors
020895
50
25
4