Jeppesen Marine Workboat Navigator 1.3 - Manual (Page 112)

104
Jeppesen Workboat Navigator User’s Guide Jeppesen Workboat Navigator User’s Guide
104
Jeppesen Workboat Navigator User’s Guide
104
Jeppesen Workboat Navigator User’s Guide
11
-
ET
A
Management
ETA - Active Route
This sub-panel is available if you are using an active route. To open this sub-panel,
click the down arrow in the top right corner of the ETA panel.
NOTE:
Activating a route clears the miles so you must reset them.
Fields in this sub-panel include:
Average Speed
Use Vessel SOG. Select to use your boat’s speed over ground (SOG) when
determining the distance and time to the ETA.
Specify SOG. Type a speed over ground (SOG) that will be used when
determining the time and distance to the ETA regardless of your boat’s
current SOG.
NOTE:
The selection you make under Average Speed applies to both ETAs.
User ETA Selection:
User ETA#. Select User ETA #1 through User ETA #5, if available, to set the
position in the NavInfo panel for the ending point you specify under Select a
Waypoint.
Select a Waypoint. Select a waypoint from the drop-down menu. The
distance and time to arrival will be calculated for this waypoint and will be
assigned to the ETA currently selected. Keep the following notes in mind:
User ETA #1 is always set to Active Point.
User ETA #2, 3, and 4 always use Auto Advance by default. You can
select another value, such as end point or another point.
User ETA #5 is set to End Point by default but you can select another
value.
NOTE:
If you deactivate a route, the selected waypoints will be cleared and you
must complete the setup process again after you reactivate that route.
Figure 11.3 - ETA Active Route
•
•
•
•
•
•
*
*
*