Jeppesen Marine Workboat Navigator 1.3 - Manual (Page 65)

57 57
7
-
SysInfo
Pane
7 - SysInfo Window Pane
Properties Panel
The SysInfo window pane Properties panel displays detailed information about all
Nav Objects in the Chart window pane, as well as Chart properties. Some content
can be edited, such as Route, Waypoint, Mark, Boat and other User-created
object properties. The Chart name and other chart data is read-only.
Click on any object in the Chart window pane to view that object’s name, Lat/Lon
and other information available for that object in the SysInfo Properties panel.
NOTE:
See the Nav Objects chapter for full descriptions of Nav Object
properties.
Boat Properties
The Boat Properties window is where you view and configure your Tow to precise
configurations. When you open this window, the current or default settings appear.
Displayed Standard Boat Properties cannot be edited from this window. See the
Workboat Navigator Installer’s Guide to edit Standard Boat Properties.
Standard Boat Properties include Boat Name/ID, Length, Width, Draft, Air Draft,
GPS Bow Offset and GPS Port Offset.
GPS Bow Offset is the distance from the bow of your boat to the location of the
GPS antenna.
GPS Port Offset is the distance from the port of your boat to the location of the
GPS antenna.
Units of measurement displayed in the Standard Boat Properties are contingent on
the values selected from System Menu | Tools/Settings | Options | Units.
Show Heading Line. Heading Line indicates the heading of the boat and originates
from the GPS transmitted position, extending 15 miles. The direction of the heading
line is based on input from the heading sensor. If no heading input is detected, the
Heading Line is based on the COG value. Default setting for this option is On.
Stern Flash Line
Heading Line
Figure 7.8 - Heading Line/Stern Flash Line
Show Stern Flash Line. The Stern Flash Line is drawn 180 degrees from the
Heading Line, and also originates from GPS position, extending 15 miles. The
direction of the Stern Flash Line is based on input from the heading sensor. If no
heading input is detected, the Stern Flash Line is based on the COG value. Default
setting for this option is On.
•
•