Jeppesen Marine Workboat Navigator 1.3 - Manual (Page 121)

113 113 113 113
12
-
Radar
12 - Radar Management
Target Label Settings. This window gives you the ability to tailor the contents of
the targets labels on the chart screen. Options available are:
Target Name
Speed Over Ground (SOG)
Closest Point of Approach (CPA)
Time to Closes Point of Approach (TCPA)
Time To Passing point (TTP)
Passing Plan (Plan)
You can also determine the size of the font by selecting it in the Label Font Size
drop-down menu.
AIS Target Settings. Use this window to set up range and speed over ground
filtering for AIS targets. The settings only become applicable when you select the
Filter check box in the All Targets sub panel.
Show AIS Targets. Select this check box to display AIS Targets on the chart.
Do not display AIS Targets beyond the range of:. Select an option from the
drop-down menu and only targets inside that range will appear on the chart
when you select the Filter check box on the All Targets sub panel.
Filter AIS Targets when SOG less than:. Select this check box if you want to
exclude targets that meet your speed criteria. When you select this check box,
the edit field becomes active and you can enter the value you want to use as
the cutoff. Targets going slower than that speed are the ones that will be filtered.
This is limited to a specific range of .1 to 20 miles. Only targets inside that range
will appear on the chart when you select the Filter check box on the All Targets
sub panel.
NOTE:
To reduce clutter on the chart and in the panel, labels are filtered by
SOG (Speed Over Ground) if more than 10 targets are visible.
•
•
•
•
•
•
•
•
•