Jeppesen Marine Workboat Navigator 1.3 - Manual (Page 58)

50
Jeppesen Workboat Navigator User’s Guide Jeppesen Workboat Navigator User’s Guide
6
-
NavInfo
Pane
50
ETA - Active Route
This sub-panel is available if you are using an active route. To open this sub-panel,
click the down arrow in the top right corner of the ETA panel.
Fields in this sub-panel include:
Average Speed
Use Vessel SOG. Select to use your boat’s speed over ground (SOG) when
determining the distance and time to the ETA.
Specify SOG. Type a speed over ground (SOG) that will be used when
determining the time and distance to the ETA regardless of your boat’s
current SOG.
NOTE:
The selection you make under Average Speed applies to both ETAs.
User ETA Selection:
User ETA#. Select User ETA #1 or User ETA #2 to set the position in the
NavInfo panel for the ending point you specify under Select a Waypoint.
Select a Waypoint. Select a waypoint from the drop-down menu. The
distance and time to arrival will be calculated for this waypoint and will be
assigned to the ETA currently selected. Workboat Navigator uses the first
and the last waypoints as defaults.
NOTE:
If you deactivate a route, the selected waypoints will be cleared and you
must complete the setup process again after you reactivate that route.
Figure 6.5 - ETA - Active Route
•
•
•
•
•
•