Fluke Biomedical TNT 12000 - Manual (Page 17)

Introduction
RF Certification
1
1-5
United States
The transceivers used in the TNT 12000 have been approved for use in the United States
by FCC Part 15 certification, FCC ID: OUR-XBEE. The following statement
accompanies the device:
“Contains FCC ID: OUR-XBEE"
The enclosed device complies with Part 15 of the FCC rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference and (2) this
device must accept any interference received, including interference that may cause
undesired operation.
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures: Re-orient or relocate
the receiving antenna, increase the separation between the equipment and receiver,
connect equipment and receiver to outlets on different circuits, or consult the dealer or an
experienced radio/television technician for help.
W Warning
To satisfy FCC RF exposure requirements for mobile
transmitting devices, a separation distance of 20 cm or more
should be maintained between the antenna of this device and
persons during device operation. To ensure compliance,
operations at closer than this distance is not recommended.
The antenna used for this transmitter must not be co-located in
conjunction with any other antenna or transmitter.
Canada
The transceiver used in the TNT 12000 has been certified for use in Canada, IC
certification number IC: 4214A-XBEE.
Europe
The transceiver used in the TNT 12000 conforms to European Union EMC Directive
2004/108/EC, ETSI EN 301 489-1 and EN 301 489-17; and R&TTE Directive
1999/5/EC, ETSI EN300 328.
Japan
Japan ID: 005NYCA0378