Fluke Biomedical TNT 12000 - Manual (Page 66)

TNT 12000
Users Manual
2-38
fct255.png
The temperature and pressure values are internal sensor measurements. The bias voltage
and leakage current are values measured in the ion chamber. If these values are more than
the measurement limits, High or Low shows as the value.
How to Use the mAs Detector (TNT 12000 mAs)
When the mAs Detector selection is made from the connection screen, the MAS
MEASUREMENT OPTION screen shows if the mAs input type is not set. See Figure 2-
16.
fct15.bmp
Figure 2-16. mAs Measurement Option Screen
If the input type is set, the MEASUREMENT screen shows in the Display. See the How
to Measure mAs section below.
To set the input measurement option to shunt, highlight the Cancel button and push
E
. The current shunt is the default selection.
To set the input measurement option to clamp, highlight OK and push E. The
SHUNT OR CLAMP screen shows in the Display. See Figure 2-17.