Fluke Biomedical TNT 12000 - Manual (Page 88)

TNT 12000
Users Manual
3-12
Table 3-2. DoseMate Excel Add-In Menu and Toolbar Options
Option Description
Battery Shows the battery status of the connected Detector
Connection Looks for available Detectors.
Template Used to set the Fluoro, Radio, or Mammo template.
Reset Used to manually reset the Detector for a new exposure.
Ion Chamber Opens the ION CHAMBER SETUP window. All the ion chambers available,
along with cal factor names, are shown in the window. There are options to
select, add, edit, and delete ion chambers and calibration factors.
DM Mode Opens the Mode window. Here you can:
Set Air Density Correction ON/OFF.
Set Temperature/Pressure compensation to internal or external.
Enter temperature and/or pressure values for external temperature/pressure
mode.
Select the dose mode.
Auto reset.
Units Opens the UNIT SETUP window where you can make a units of measurement
selection for dose, dose rate, temperature, pressure, and enter frame rate
value.
Status Opens the STATUS dialog box where temperature, pressure, air density
correction factor, bias voltage, and leakage current of the ion chamber are
shown.
Parameter configuration Sets the measured parameters to show and sets the order for each
measurement mode in the Excel add-in.
Adjust sensor The T&P screen opens if the ADCF option is on, and either temperature or
pressure is set to internal compensation.
Active only if an ion chamber is configured on the Detector and it is set in the
Detector for the measurement.
Power settings Used to set the system low power mode time and system shutdown time.
Help Shows the TNT 12000 Excel Add-In help file.
About Excel Add-In Shows the TNT 12000 Excel Add-In version, serial number, firmware version,
hardware version, and calibration date of the connected Detector. (Available
only in TNT 12000 menu)
Note
In Microsoft Excel 2003, click DoseMate tab in the toolbar to show the
DoseMate Menu.