Fluke Biomedical TNT 12000 - Manual (Page 85)

Microsoft Excel Add-In Software
TNT 12000WD Toolbar Options
3
3-9
fct313.bmp
Figure 3-8. Detector Connection Window
When you scroll through the detectors, Z or ™ appears in upper-right corner of
the screen if a connection exists between the Display and the highlighted Detector.
Calibration date, calibration due date, software version, and hardware version for the
highlighted Detector shows below the Detector list.
6. Make a Detector selection from the list.
A maximum of two Detectors can operate with the Display at one time. The X-ray or
Dosimeter Detector can operate with the mAs Detector at the same time. The X-ray
Detector and Dosimeter Detector can not operate with the Display at the same time.
7. Click Connect or Always Connect to connect the PC with the Detector.
8. Make a worksheet selection and put the cursor on the cell where the data is to be put.
The measurement data is automatically put into the active worksheet cell after the
measurement.
Note
To learn more on how to use the PC Excel Add-In, refer to the TNT 12000
Excel Add-In Software Help. It is available in the TNT 12000 drop-down
menu or the toolbar.
TNT 12000WD Toolbar Options
Figures 3-9 and 3-10 shows the TNT 12000WD drop-down menu and toolbar. See the
toolbar option descriptions in Table 3-1.
Note
In Microsoft Excel 2007, click the Add-Ins tab in the toolbar to show the
TNT 12000 menu and toolbar.