Editing an area on the map, Deleting an area on the map – GAI-Tronics Sonic Alarm Sonic Alarm System Software Programming and User Manual User Manual
Page 32
Pub. 42004-410A
Sonic Alarm™ System Programming and User Manual
Page: 29 of 98
f:\standard ioms - current release\42004 instr. manuals\42004-410a.doc
03/09
Editing an Area on the Map
To make changes to the area that was previously drawn, RIGHT click anywhere in the highlighted area
and select “Edit Area” as shown below; or select the area by LEFT clicking then selecting the Edit Zone
icon on the tool bar.
The line anchor points will then appear. You can move each anchor point by LEFT clicking and dragging
it to the new position. The line will follow the anchor point. When done, RIGHT click the mouse and
select “End Edit.”
Deleting an Area on the Map
To erase an area that was previously drawn, RIGHT click anywhere in the highlighted area and select
“Delete” from the menu shown above; or select area by LEFT clicking then selecting the Delete Zone
icon on the tool bar.