GAI-Tronics Sonic Alarm Sonic Alarm System Software Programming and User Manual - Manual (Page 8)

Pub. 42004-410A
Sonic Alarm™ System Programming and User Manual Page: 5 of 98
f:\standard ioms - current release\42004 instr. manuals\42004-410a.doc
03/09
Assigning RTU Parameters
Select each RTU icon one at a time. Home screen
Select RTU Fault Output (pull-down list). RTU screen
Enable /Disable RTU Polling (checkbox). RTU screen
Select if an AMI is connected to the RTU (checkbox). RTU screen
Select each INPUT to be used and assign parameters for
each.
•
Description (text entry)
•
Event Type (pull-down list)
•
Event Description (pull-down list)
•
Switch Type (pull-down list)
•
Switch Mode (pull-down list)
RTU screen – Input tab
Select each OUTPUT to be used and assign parameters for
each.
• Description (text entry)
• Event Type (pull-down list)
• Event Description (pull-down list)
• Output Type (pull-down list)
• Should output follow the event broadcast (check-box)
RTU screen – Output tab
Select each ANALOG INPUT to be used and assign
parameters for each.
• Description (text entry)
• Event Type (pull-down list)
• Event Description (pull-down list)
• Select valid Voltage Range (slide-bar)
RTU screen – Analog tab