GAI-Tronics Sonic Alarm Sonic Alarm System Software Programming and User Manual - Manual (Page 61)

Pub. 42004-410A
Sonic Alarm™ System Programming and User Manual Page: 58 of 98
f:\standard ioms - current release\42004 instr. manuals\42004-410a.doc
03/09
Broadcast List Status
Event is the description of the active event(s). The event descriptions are entered during the system
configuration process.
Type is the type of event either Alarm or Page.
Status is the current “play” status of the event.
• BROADCASTING - means the event is playing.
• QUEUED, means the event is active but not playing because a higher priority event is also active.
Location identifies the address of the RTU that activated the event. If the event was activated from a
MapGUI user, the IP address of the user’s PC is listed.
Input identifies the input number (1–32) of the RTU that activated the event. If the event was activated
from a MapGUI user, the field is not populated.
Priority identifies the priority of the event (1–10).
Count - This field is only used for Alarm events that are programmed to have an AMI message play “X”
number of times. The field displays how many times the alarm message has played. Each time the
message is played, the count increments until the programmed play count is reached.
Timer - This field is used for timed paging events and timed alarm events that do not play an AMI
message. The amount of time remaining for the alarm or page event is displayed. The time counts down
to zero.
Destination identifies the RTU address numbers that are receiving the page or alarm event .