GAI-Tronics Sonic Alarm Sonic Alarm System Software Programming and User Manual User Manual
Page 34
Pub. 42004-410A
Sonic Alarm™ System Programming and User Manual
Page: 31 of 98
f:\standard ioms - current release\42004 instr. manuals\42004-410a.doc
03/09
Setting the Position of Activity Icons and Pop-up Text
An icon and a pop-up text widow will appear whenever there is activity at any RTU(s) in the assigned
destination. Also, when an operator selects the area using the MapGUI program, the description will be
shown in the text window.
The location of the ball determines where the activity icon will appear on the screen. The activity icons
are shown below.
Alarm Icon
Paging Icon
To move the ball, LEFT click on it then drag it to the desired position.
The pop-up text window will be displayed near the activity icon. It can be displayed in any quadrant
around the icon (top-left, top-right, bottom-left, bottom-right). To select the location, RIGHT click on the
ball and select “Pop-Up Position” as shown above. The following screen will be displayed.
Select location 1–4 to determine the text window position relevant to the
icon.