Communication port connectivity – NavCom SF-3050 Rev.I User Manual
Page 114
SF-3050 GNSS Product User Guide
– Rev I
95
Figure 107: SF-3050 Base Plate Dimensions Without Mounting Brackets
Figure 108: SF-3050 Base Plate Dimensions with Mounting Brackets
Communication Port Connectivity
There is no default control port or data port on the receiver. COM1 - LAN is the only
Ethernet (LAN) compliant port. COM2 - USB is the only USB compliant port.
Establish communications via Bluetooth or a data cable:
Setup Bluetooth communications via either the supplied StarUtil 3000 utility or a third
party software/utility.
Connect the Positronic 9-Pin connector of the supplied DB9S cable (P/N 94-310260-
3006LF) to COM1 - LAN (RS-232/1PPS) or COM2 - USB (RS-232/RS-422) of the SF-
3050. Connect the DB9S end to the control device.
Connect the Positronic 9-Pin connector of the supplied USB 2.0 Device cable (P/N 94-
310266-3006LF) to COM2 - USB of the SF-3050. Connect the USB plug end to the
control device.
09-00012-A
4
.6
0
"
[1
1
7
m
m
]
6.47" [164mm]
4.24"
[108mm]
2.37"
[60mm]
09-00011-A
0.41"
[10mm]
5
.7
0
"
[1
4
5
m
m
]
6
.5
2
"
[1
6
6
m
m
]
0.16"
[4.0mm]
5.78" [147mm]
2.46"
[62mm]
4
.8
1
"
[1
2
2
m
m
]
6.47" [164mm]