NavCom SF-3050 Rev.I - Manual (Page 26)

SF-3050 GNSS Product User Guide – Rev I
7
Figure 6: Connection at Incorrect Baud Rate

For remote operation, connection to either Com 1 or Com 2 is highly
recommended as a backup to the Ethernet interface. The Com1 or Com 2
backup connection can be made via a cell modem, MOXA to Ethernet, etc.
Determine Current Firmware Versions
The user determines if the most current firmware is installed in the SF-3050. The version
of the installed firmware is important to ensure the proper operation of the receiver.
In StarUtil 3000, checking the contents of the Firmware Info window (see Figure 7) on the
Receiver Options tab is the easiest way to determine if the installed firmware is the most
current. An alternative method is to use the Input Terminal window (see Determine
Firmware Version via the Input Terminal, below).
19. Click Receiver Options on the Detailed Views menu to open the Receiver Options tab
(see Figure 7).
Figure 7: Access to Receiver Options Tab
20. Click (refresh) on the Firmware Info window to view the current output data (see
Figure 8).

The firmware is identified by version number. For example, the NAV
firmware in the example below is version 01.00.00.003. Firmware
ensembles are always referenced to the Navigation Firmware Number.
Firmware Info Window