NavCom SF-3050 Rev.I - Manual (Page 157)

SF-3050 GNSS Product User Guide – Rev I
E-138
1. Configure the SF-3050 to receive corrections from the caster via the modem.
2. Connect to the caster:
[NTRIPCLIENT]CONNECT
3. Verify that the ECHODGPSB message indicates that RTCM 3.0 corrections are being
received.
4. Verify that both the PVT1B and RTKSTATUS1B screens indicate that the navigation
status achieves “RTK Dual Fixed: RTCM3-Dual Full”. This may take several seconds.
5. Enter the following command to disconnect from the caster:
[NTRIPCLIENT]DISCONNECT
Refer to the Sapphire Technical Reference Manual for detailed instructions on the
[ECHODGPSB], [MODEMCONFIG], [NTRIPCLIENT], [NTRIPSERVER], [OUTPUT], and
[RTKMODE] commands.

The NTRIP client and server cannot both be active at the same time. An
error message will be displayed if any keyword other than a status request
or DISCONNECT is issued to one while the other is active.

To send or receive corrections via Ethernet instead of a modem, configure
the SF-3050 for Ethernet.