NavCom SF-3050 Rev.I - Manual (Page 130)

SF-3050 GNSS Product User Guide – Rev I
111
Chapter 7 ........................................................... Safety Instructions
The SF-3050 GNSS sensor is designed for precise navigation and positioning using the
Global Positioning System, GLONASS. Users must be familiar with the use of portable
GNSS equipment, the limitations thereof and these safety instructions prior to use of this
equipment.
Transport
Always carry the NavCom equipment in either the original packing material or packaging
which provides protection to the receiver and antenna against shock and vibration.
Utilize all original packaging when transporting via rail, ship, or air.
Maintenance
The NavCom equipment may be cleaned using a new lint free cloth moistened with pure
alcohol.
Connectors must be inspected, and if necessary cleaned before use. Always use the
provided connector protective caps to minimize moisture and dirt ingress.
Inspect cables regularly for kinks and cuts as these may cause interference and
equipment failure.
Damp equipment must be dried at a temperature less than +40

C (104

F), but greater
than 5

C (41

F) at the earliest opportunity.
External Power Source
Early SF-3050 production units are supplied with an
external power cable without a filter (P/N 94-310262-3010LF). Later SF-3050 production
units are supplied with an external power cable with a filter
(P/N 94-310274-3010LF)
The power cable must be connected to the chosen external power solution in accordance
with Chapter 3 Interfacing/Electrical Power. It is important that the external power source
allow sufficient current draw for proper operation. Insufficient supplied current will cause
damage to your external power source.
If your chosen external power source is a disposable battery, please dispose of the
battery in accordance with your local regulations.
Safety First
The owner of this equipment must ensure that all users are properly trained prior to using
the equipment and are aware of the potential hazards and how to avoid them.
Other manufacturer’s equipment must be used in accordance with the safety instructions
issued by that manufacturer. This includes other
manufacturer’s equipment that may be
attached to NavCom Technology, Inc. manufactured equipment.
Always use the equipment in accordance with local regulatory practices for safety and
health at work.