NavCom SF-3050 Rev.I - Manual (Page 31)

SF-3050 GNSS Product User Guide – Rev I
12

The SF-3050 returns the entire list of loaded software options. However,
StarUtil 3000 does not display the entire list in the Software Options
window. Perform steps 55 through 58 to confirm the software uploaded to
the receiver.
37. Type the command [INPUTSWOPTION] on the Input Terminal window.
38. Click Send.
39. Highlight and copy the entire output.
40. Open any text editor (e.g., Microsoft Notepad) and paste the output there to verify that
all software options have been uploaded to the receiver.

If the above method fails to upload any of the purchased software options,
refer to the next section.
Upload Software Options via the Input Terminal
Perform steps 12 through 17 to upload software options via the Input Terminal.
41. Open the software option file in any text editing program (e.g., Notepad).
42. Locate the option code at the bottom of the file (e.g., 74C91E91 789FA173 8E70296A
3259B2E6).
43. Highlight and copy the option code.
44. Enter the command [INPUTSWOPTION] on the Input Terminal window and then
paste the option code: 74C91E91 789FA173 8E70296A 3259B2E6.
45. Click Send on the Input Terminal window. If the software options loaded successfully,
the Input Terminal window displays a confirmation message (see Figure 16).
46. To view all currently loaded software options, click (refresh) on the Software
Options window (see Figure 17).
Upload Firmware

The required PC Baud rate to upload firmware via the supplied DB9S cable
(RS-232) on COM2 is 57600 (default). This requirement does not apply to
the supplied USB 2.0 Device cable.

The receiver must be navigating at the time of the firmware upload.

Typically, if any firmware needs to be updated, it is NAV and PIOAPP.
Upload a Unified Firmware File
47. Click Receiver Options on the Detailed Views menu to open the Receiver Options tab
(see Figure 18).