NavCom SF-3050 Rev.I - Manual (Page 124)

SF-3050 GNSS Product User Guide – Rev I
105
The user changes the elevation mask to 12
 in a profile named “Test”. The user
subsequently sends profile “RTK” to the receiver. It replaces “Test” and changes
navigation mode settings and port assignments.
But profile “RTK” does not specify a setting for the navigation elevation mask. So, the
elevation mask remains at 12
 , as previously set by the “Test” profile.

Refer to the Sapphire Technical Reference Manual for detailed information
on the [PROFILE] and [USEPROFILE] commands (see Related
Documents in the fore-matter).
Profile NONE
The command [USEPROFILE] NONE resets all of the user-controlled configuration
parameters to the factory default values. The receiver’s profile remains set to NONE until
another profile is successfully input.

The profile NONE is subject to change.
Avoiding User Profile Loading Errors
StarUtil 3000 v.1.0.0 and later scans user profiles before loading them to adjust port
settings and reduce the likelihood of communication errors. Communication errors still
occur, and this section aids in resolving common issues.
As a user profile is loaded into the receiver, each command line is acted upon as it is
received. A profile loading error occurs if the communication link between the PC and the
receiver is broken before all command lines are received. To avoid this loading error, the
best practice is to preview the control port baud rate in a user profile before loading the
profile. Refer to the StarUtil 3000 User Guide for detailed instructions.
Third-Party Controller Configuration Settings
Refer to the third-party controller solution manual/user guide if your SF-3050 GNSS
sensor is part of an integrated solution.
Over the Air StarFire Licensing
Over the Air (OTA) StarFire Licensing is the easiest way to install a StarFire license. The
installation of a purchased license is accomplished via radio broadcast. Over the Air
StarFire Licensing is especially convenient for receivers in remote locations in the field.
These are the requirements for obtaining a StarFire license:
 Valid Purchase Order
 Signed License Agreement
 Appropriate Credit Terms with NavCom Technology or an Authorized Dealer;including
a valid P.O.