NavCom SF-3050 Rev.I - Manual (Page 41)

SF-3050 GNSS Product User Guide – Rev I
22
Refer to the [NAVMEASUSE] command in the Sapphire Technical Reference Manual for
detailed instructions on enabling and disabling navigation signals and frequencies. Also
refer to the StarUtil 3000 User Guide.

This command is used primarily for engineering experiments or receiver
testing. It is not recommended for use in other applications.
Upload WebPages
1. Update firmware on SF-3050 receiver. The latest version of the software (v3.3.x.0 or
later) is required for this feature.
2. Determine the receiver’s IP address OR give it a static IP address by entering the
[ETHCONFIG] command in the Input Terminal screen.

Specify [ETHCONFIG]MANUAL to manually change the IP address.

Using [ETHCONFIG]AUTO will automatically set the IP address.
Figure 39: Input Terminal
– [ETHCONFIG]

The IP address consists of the first four sets of three numbers separated
by periods. For further information on this command, see the Technical
Reference Manual.
3. Save the profile by entering [PRO
FILE]SAVEAS “XXX” in the Input Terminal screen
where the Xs indicate the name chosen for the profile.
Figure 40: Input Terminal – Save Profile

If the profile is not saved, the IP address will be lost the next time the
receiver is shut off and rebooted.