Configuration – NavCom StarUtil-3000 Rev.G User Manual
Page 176
StarUtil 3000 User Guide
– Rev G
12-174
Configuration
Use the commands described below to configure 1PPS and Events via the Input Terminal
window.
Refer to the Sapphire Technical Reference Manual for details on these commands
(see Related Documents in the fore-matter).
EVENTLATCH: This command is used to enable the operation of the event latch feature in the
two ports available and sets the event latch time tag to be triggered by the rising or falling edge
of the external pulse.
EVENTLATCHA: This output message reports the time of events that are captured by either of
the two event latch ports.
1PPS: This command is used to set up and control the output of the programmable PPS signal.
1PPSA: This output message reports UTC time that the next PPS will occur. The 1PPSA
message is sent out approximately 10ms before the 1PPS pulse.
Use the [OUTPUT]EVENTLATCHA, ONCHANGE, ,<PORT> command to schedule
the EVENTLATCHA message.