NavCom StarUtil-3000 Rev.G - Manual (Page 60)

StarUtil 3000 User Guide – Rev G
2-58
Configure the Radio Modem (SF-3040)

For detailed instructions on installing the radio modem, refer to the SF-3040 UHF
Radio Module Installation Guide tucked inside the radio modem kit and the
SF-3040 GNSS Receiver Product User Guide, Chapter 7. Also refer to Configure
the Radio Settings in Chapter 8 of this guide, Configure the Radio Settings (SF-
3040)

Refer to Figure 53 for the steps below:
1. On the Receiver Setup menu, click Configure SF-3040 Radio (refer to Figure 52).
Figure 52: Receiver Setup/Configure SF-3040 Radio
2. To turn on the radio, select the ON option.
3. To set a frequency other than the default frequency, type a frequency between 403.00000
and 473.000000 in the FREQUENCY in MHz (in 25KHz steps) text box.
4. To set the receiver sensitivity threshold power level other than the default power level, type
a power level between -118 and -80 in the RX Threshold in dBm text box. A larger value (i.e.
closer to -80) makes the receiver less sensitive, which means the base and rover need to be
closer together for the radio link to function properly.
5. To use a network ID other than the default ID, type a network ID between 0 and 4090 in the
NETWORK ID text box.
6. Select a Channel Width option: 12.5 kHz or 25 kHz.
7. Select a Protocol Option: Satel 3AS (0); Pacific Crest 4-FSK (1); Pacific Crest GMSK 92);
TRIMTALK GMSK (3.) Options (1) (2) and (3) are Trimble receiver protocols.
8. Click to send the configuration to the radio using the selected parameters.

The radio settings can also be configured via the Input Terminal. Refer to the
[RADIO] and [OUTPUT]RADIOSTAT commands in the Sapphire Technical
Reference Manual.