Connect sf-3050 to the pc, Figure 50: internet protocol – NavCom StarUtil-3000 Rev.G User Manual
Page 58
StarUtil 3000 User Guide
– Rev G
2-56
Figure 50: Internet Protocol
7. Enter the IP address for the PC. In this case, enter 192.168.0.100.
The first part of the IP address, 192.168.0, is the same for the SF-3050 and the PC. The last
part of the IP address must be unique for every device. In this case, it is 100 for the PC.
8. Press the Tab button on the keyboard. The Subnet mask is automatically populated.
9. Click the OK button on this dialog box and also on the Local Area Connection dialog box.
10. Continue to the next section for connection instructions.
Connect SF-3050 to the PC
1. Open StarUtil 3000.
2. Click the Connections button to establish communications between the PC and the
SF-3050 (see Figure 29). The Port Configuration dialog box opens.
Refer to Figure 51 for the steps below:
3. Select Ethernet as the Connection Type.
Do not change the default Ethernet Settings: 192.168.1.2 is the factory default IP
address of the SF-3050. The default virtual COM port is 4361 (logical port ETH1) and
the protocol is UDP2.