Grass Valley GV STRATUS v.3.1 - Manual (Page 124)

2. To change the working bin, do the following:
a) Right-click anywhere within the channel and select Edit Working Bin .
The Channel Panel configuration opens in the Inspector and the working bin control expands.
b) Select the working bin.
NOTE: The working bin is set for all the channels from the same K2 system used in the
Channel Panel.
3. Click the the Save button in the toolbar.
4. When prompted to confirm, click Replace .
This updates the current Channel Panel configuration with your changes.
If you close and then launch the Channel Panel your changes remain in effect.
Resizing channels and gangs
• To resize channels, in the Channel Panel toolbar identify the View Mode button and use it
as follows:
• Click the button to toggle between small, medium, and large size channels.
• Click the drop-down arrow and select Small, Medium, or Large.
• Click the drop-down arrow and drag the slider to the desired size.
• To resize a gang, drag the sides, bottom, or lower right corner of the Channel Panel.
Channels automatically align horizontally or vertically as you resize.
Modifying a Channel Panel configuration
You can use the Channel Panel configuration to change the channels included in a Channel Panel
and the gangs to which they are assigned.
1. In the Navigator panel expand the Tools node and select Channel Panels .
Your Channel Panel configuration is displayed in the Asset List.
2. Right-click the Channel Panel configuration and select Open .
Channel Panel settings open.
3. Change settings as desired.
4. Do one of the following:
• To save your changes when the Channel Panel is launched, click Apply . The changes take
effect in the Channel Panel.
• To save your changes when the Channel Panel is not launched, click Launch . The Channel
Panel launches with the changes in effect.
• To discard your changes, click Revert . The settings present when you opened the Channel
Panel configuration are restored.
124 GV STRATUS User Manual 2014 02 21
Working with K2 channels