Grass Valley GV STRATUS v.3.1 - Manual (Page 135)

3. Click the Play button. ( W )
Playback begins on the channel.
4. Toggle between A and B angles as desired during playback.
NOTE: You can only toggle between A and B angles for playback of ganged recorded assets.
Playing a clip on a single channel in loop play
1. Launch a Channel Panel.
2. Load an asset into a channel so that it is cued up and ready to play.
3. Click the Loop Playback button.
The channel is now cued in loop play mode, as indicated by the highlighted loop play button.
4. Click the Play button. ( W )
Loop play begins on the channel. When the clip reaches its end, it automatically starts to play
again from its beginning.
5. Control loop play as follows:
• To pause loop play, click the Pause button.
• To resume loop play, click the Play button. When loop play restarts it begins at the point
from which it stopped.
• To stop loop play when it reaches the end of the clip, click the Loop Playback button.
Playout continues normally and stops at the end of the clip.
Spacebar = Play/Pause. Toggles between play and pause.
Related Topics
About keyboard shortcuts and input focus in a Channel Panel on page 145
Configuring Channel Panel User Preferences on page 117
Playing ganged channels in loop play
1. Launch a Channel Panel.
2. Load assets into channels so they are cued up and ready to play. You can load the same asset on
all channels or load different assets on individual channels.
3. Click the Loop Playback button.
The gang is now cued in loop play mode, as indicated by the highlighted loop play button.
2014 02 21 GV STRATUS User Manual 135
Working with K2 channels