Grass Valley GV STRATUS v.3.1 - Manual (Page 260)

5. Repeat above steps to create more segmentation panels, if needed.
You can create multiple Segmentation panels to assign different segments of an asset for different
broadcast times.
You can also drag the Segmentation icon on the segmentation panel into the Inspector if you
want to change the panel name later.
Assigning segments to assets
You can assign segments to an asset in the Segmentation panel. Segments are created in the Source
Viewer panel by marking in and out specific part of the asset.
1. Drag the selected asset from Asset List into the Source Viewer in the Segmentation panel.
2. If the logging controls are not shown, click the Show/Hide Control Tray button to show the
controls, then the drop-down arrow at the right of the control tray and Add/Remove buttons if
necessary.
3. Navigate to the starting point and click the Mark In button. ( I )
4. Determine the end-point of your segment and click the Mark Out button. ( O )
5. Click on the asset in the Source Viewer, then drag and drop the segment into the Segmentation
panel. ( CTL + ~ )
The segment adds into the Segmentation panel.
6. Repeat above steps to add more segments of the asset into the Segmentation panel.
You can also create multiple segments of an asset for different broadcast times. For example, a
program that is scheduled for prime time has more commercial slots compared to the repeat of the
same program at a different time. Therefore, several kinds of segmentations can be created for the
same asset.
260 GV STRATUS User Manual 2014 02 21
Integrating assets with traffic system and K2 Edge