TA Triumph-Adler P-C4580DN - Manual (Page 165)

6-41
Operation Panel
IPv4 Setting (TCP/IP IPv4 settings)
This selects the settings for TCP/IP (IPv4).
1
In the TCP/IP Settings menu, press  or  to select IPv4
Setting .
2
Press [OK]. The IPv4 Setting menu screen appears.
The options available in the TCP/IP (IPv4) settings are as follows:
• DHCP (DHCP setting)...6-41
• Auto-IP (Auto-IP setting)...6-41
• IP Address (IP address setting)...6-42
• Subnet Mask (Subnet mask setting)...6-42
• Default Gateway (Gateway setting)...6-43
• Bonjour (Bonjour setting)...6-43
IMPORTANT The DHCP, Auto-IP, IP address, subnet mask, gateway
and Bonjour menu options for TCP/IP (IPv4 settings) are displayed
when TCP/IP is enabled.
DHCP (DHCP setting)
Select whether or not to use the DHCP server. The default setting is On.
1
In the IPv4 Setting menu, press
 or  to select DHCP.
2
Press [OK]. The DHCP screen appears.
3
Press  or  to select whether DHCP is enabled.
4
Press [OK]. The DHCP setting is set and the IPv4 Setting menu
reappears.
Auto-IP (Auto-IP setting)
Select whether or not to use Auto-IP. The default setting is On.
1
In the IPv4 Setting menu, press  or  to select Auto-IP.
2
Press [OK]. The Auto-IP screen appears.
3
Press
 or  to select whether Auto-IP is enabled.
4
Press [OK]. The DHCP setting is set and the IPv4 Setting menu
reappears.
IPv4 Setting:
a b
********************-
2 Auto-IP
3 IP Address
[ Exit ]
1 DHCP
DHCP:
a b
1 Off
********************-
2
*On
Auto-IP:
a b
1 Off
********************-
2
*On