TA Triumph-Adler P-C4580DN - Manual (Page 198)

Operation Panel
6-74
Sleep Timer (Sleep timer timeout time)
You can adjust the length of time the printer waits before entering Auto Sleep in the absence of data. The printer reverts to
normal operation mode when the printer receives a print job, [OK] is pressed or one of the exterior covers is opened. The
default time is 60 minutes.
1
In the Timer Setting menu, press  or  to select Sleep Timer.
2
Press [OK]. The Sleep Timer screen appears.
3
Use the numeric keys to set the sleep time.
4
Press [OK]. The sleep time setting is stored and the Timer Setting
menu reappears.
Auto Err. Clear (Auto error clear setting)
If an error that still allows you to continue printing occurs, the next received data is automatically printed after a set period
of time elapses.
For example, if the printer is shared over a network as a network printer and one person causes one of the above errors,
after the set period of time elapses, the data sent from the next person is printed. The default setting is Off (Auto Error
Clear disabled).
The auto clear errors are:
Print overrun.
KPDL error.
HDD error.
Incorrect account ID.
Account error.
Cannot duplex print on this paper.
Job Accounting restriction exceeded.
No multi copies.
USB memory error.
Restricted by Job Accounting.
Job not stored.
For the procedure for setting the automatic error recovery time, refer to Err. Clear Timer (Setting the error clear time) on
page 6-75.
Sleep Timer:
a b
(1 - 240)
/60-min.