TA Triumph-Adler P-C4580DN - Manual (Page 167)

6-43
Operation Panel
Default Gateway (Gateway setting)
Set the IP gateway addresses.
1
In the IPv4 Setting menu, press  or  to select Default
Gateway .
2
Press [OK]. The Default Gateway screen appears.
3
Use the numeric keys to set the default gateway.
You can set any value between 000 and 255.
Increase or reduce the figures by pressing  or .
Use
 and  to move the position being entered, which is shown
highlighted.
4
Press [OK]. The default gateway is stored and the IPv4 Setting menu
reappears.
Bonjour (Bonjour setting)
Select whether or not to use Bonjour. The default setting is On.
IMPORTANT After changing the setting, restart the network, or turn the machine OFF and then ON. For detailed
information on restarting the network, refer to Restart Network (Restarting the network card) on page 6-47.
1
In the IPv4 Setting menu, press  or  to select Bonjour.
2
Press [OK]. The Bonjour screen appears.
3
Press  or  to select whether automatic detection is enabled.
4
Press [OK]. The automatic detection setting is set and the IPv4
Setting menu reappears.
Note Before you input the gateway, be sure to set the DHCP setting to Off.
Default Gateway:
a b
/**0. 0. 0. 0
Bonjour:
a b
1 Off
********************-
2
*On