TA Triumph-Adler P-C4580DN - Manual (Page 43)

2-19
Preparation before Use
2
Enter the correct settings in each field.
The settings to be specified in the SMTP settings screen are shown
below.
Dynamic Domain Name System (DDNS)
This printer supports DDNS through DHCP. To use this system, you have to set the DHCP/BOOTP option to On first.
Set the DDNS to On to use the DDNS service to update the correspondence of the host names and IP addresses.
Refer to the Embedded Web Server RX User Guide for the method for setting this.
Item Description
SMTP Protocol Enables or disables SMTP protocol. To use E-mail, this protocol must be enabled.
SMTP Port Number Set the SMTP Port Number. Normally use the port No. 25.
SMTP Server Name Enter the SMTP server IP address or its name. The maximum length of the SMTP
server name and IP address is 64 characters.
If entering the server name, an IP address of DNS server must also be configured.
The DNS server address can be entered on the TCP/IP setting screen.
SMTP Server Timeout Set the amount of time to wait before time-out in seconds.
Authentication Protocol Enables or disables the SMTP authentication protocol or sets POP before SMTP as
the protocol. The SMTP authentication supports Microsoft Exchange 2000.
Authenticate as Authentication can be set from three POP3 accounts or you can choose a different
account.
Login User Name When Other is selected for Authentication, the login user name entered here will be
used for SMTP authentication. The maximum length of the login user name is 64
characters.
Login Password When Other is selected for Authentication, the password entered here will be used for
authentication. The maximum length of the login password is 64 characters.
SMTP Security Enables or disables the SMTP Security. When this protocol is enabled, either SSL/TLS
or STARTTLS must be selected. To enable SMTP security, the SMTP port number may
have to be changed according to the server settings.
Typically, 465 for SSL/TLS and 25 or 587 for STARTTLS are used for SMTP ports.
POP before SMTP Timeout Set the amount of time to wait before time-out in seconds when you have selected
POP before SMTP as the Authentication Protocol.
Test This will test if the SMTP connection can be successfully established.
E-mail Size Limit Enter the maximum size of E-mail that can be sent in kilobytes. When the value is 0,
the limitation for E-mail size is disabled.
Sender Address Enter the E-mail address of the person responsible for the machine, such as the
machine administrator, so that a reply or non-delivery report will go to a person rather
than to the machine. The sender address must be entered correctly for SMTP
authentication. The maximum length of the sender address is 128 characters.
Signature Enter the signature. The signature is free form text that will appear at the end of the E-
mail body. It is occasionally used for further identification of the print system. The
maximum length of the signature is 512 characters.
Domain Restriction Enter the domain names that can be permitted or rejected. The maximum length of the
domain name is 32 characters. You can also specify the E-mail addresses.