ProSoft Technology PTQ-104S - Manual (Page 116)

Diagnostics and Troubleshooting 48TPTQ-104S Rev 1 ♦ 47TQuantum Platform
12TUser Manual 46TIEC 60870-5-104 Server for Quantum
Resetting diagnostic data
Press [U] to reset the status counters for the client and/or servers in the module.
Viewing Version Information
Press [V] to view Version information for the module.
Use this command to view the current firmware version of the software (Software
Revision Level) for the module, as well as other important values. You may be
asked to provide this information when calling for technical support on the
product.
Values at the bottom of the display are important in determining module
operation. The Program Scan Counter value is incremented each time a
module’s program cycle is complete.
Tip: Repeat this command at one-second intervals to determine the frequency of program
execution.
Opening the IEC 870-5-104 Menu - [Z]
Press [ Z ] to view all data associated with the IEC 60870-5-104 server driver.
Exiting the Program
Caution: Some of the commands available to you from this menu are designed for advanced
debugging and system testing only, and can cause the module to stop communicating with the
processor or with other devices, resulting in potential data loss or other failures. Only use these
commands if you are specifically directed to do so by ProSoft Technology Technical Support staff.
Some of these command keys are not listed on the menu, but are active nevertheless. Please be
careful when pressing keys so that you do not accidentally execute an unwanted command.
Press [E SC ] to restart the module and force all drivers to be loaded. The module
will use the configuration stored in the module's Flash memory to configure the
module.
Page 116 of 201 ProSoft Technology, Inc.
March 4, 2013