ProSoft Technology PTQ-104S - Manual (Page 18)

Start Here 48TPTQ-104S Rev 1 ♦ 47TQuantum Platform
12TUser Manual 46TIEC 60870-5-104 Server for Quantum
If there is no response from the module, follow these steps:
1 Click to configure the connection. On the Connection Setup dialog box, select
a valid com port or other connection type supported by the module.
2 Verify that the null modem cable is connected properly between your
computer’s serial port and the module. A regular serial cable will not work.
3 On computers with more than one serial port, verify that your communication
program is connected to the same port that is connected to the module.
4 If you are still not able to establish a connection, contact ProSoft Technology
for assistance.
1.3.3 Ethernet Configuration
Use this procedure to configure the Ethernet settings for your module. You must
assign an IP address, subnet mask and module address. After you complete this
step and download the configuration to the module, you can connect to the
module with an Ethernet cable.
1 Determine the network settings for your module, with the help of your network
administrator if necessary. You will need the following information:
o
IP address (fixed IP required) _____ . _____ . _____ . _____
o Subnet mask _____ . _____ . _____ . _____
o
Gateway address _____ . _____ . _____ . _____
Note: The module Address is optional, and is not required for networks that do not use a default
module.
Page 18 of 201 ProSoft Technology, Inc.
March 4, 2013