ProSoft Technology PTQ-104S - Manual (Page 28)

Configuring the Processor with Unity Pro 48TPTQ-104S Rev 1 ♦ 47TQuantum Platform
12TUser Manual 46TIEC 60870-5-104 Server for Quantum
2.4.1 Connecting to the Processor with TCP/IP
The next step is to download (copy) the project file to the processor. The
following steps demonstrate how to use an Ethernet cable connected from the
Processor to your PC through an Ethernet hub or switch. Other connection
methods may also be available, depending on the hardware configuration of your
processor, and the communication drivers installed in Unity Pro.
1 If you have not already done so, connect your PC and the processor to an
Ethernet hub.
2 Open the PLC menu, and then choose S ET ADDRESS .
 Important: Notice that the Set Address dialog box is divided into two areas. Enter the address
and media type in the PLC area of the dialog box, not the S IMULATOR area.
3 Enter the IP address in the address field. In the M EDIA dropdown list, choose
TCPIP.
4 Click the T EST C ONNECTION button to verify that your settings are correct.
2.5 Download the Project to the Processor
1 Open the PLC menu and then choose C ONNECT . This action opens a
connection between the Unity Pro software and the processor, using the
address and media type settings you configured in the previous step.
2 On the PLC menu, choose T RANSFER P ROJECT TO PLC. This action opens
the T RANSFER P ROJECT TO PLC dialog box. If you would like the PLC to go to
"Run" mode immediately after the transfer is complete, select (check) the
PLC
R UN AFTER T RANSFER check box.
Page 28 of 201 ProSoft Technology, Inc.
March 4, 2013