ProSoft Technology PTQ-104S - Manual (Page 97)

48TPTQ-104S Rev 1 ♦ 47TQuantum Platform Module Configuration
46TIEC 60870-5-104 Server for Quantum 12TUser Manual
 DB Address
 Monitor Point #
 Monitor DB Address
Each point is four, 8-bit bytes and the DB Address value corresponds to the
double-word offset in the module memory database.
The DB Address should be located in a database area that is being constantly
moved from the Master to the Quantum.
For additional information on how to set these parameters, see the Reference
chapter of this manual.
5.22 [C_SE_NA_1 104]
This section defines the normalized setpoint database. This information is
sourced from the remote Client and is transferred to the database. You can
associate a command with a monitored normalized database value to coordinate
the command/monitor operation. You must enter the correct Monitor Point # and
Monitor DB Addr values in the table. If the Require Select parameter is not set to
zero, a select command must be received before an execute command will be
processed.
This section takes the following parameters:
 Point #
 DB Address
 Monitor Point #
 Monitor DB Address
 Require Select
Each point is one 16-bit word and the DB Address value corresponds to the word
offset in the module memory database. For additional information on how to set
these parameters, see the Reference chapter of this manual.
5.23 [C_SE_NB_1 104]
This section defines the scaled setpoint database. This information is sourced
from the remote Client and is transferred to the database. You can associate a
command with a monitored scaled database value to coordinate the
command/monitor operation. You must enter the correct Monitor Point # and
Monitor DB Addr values in the table. If the Require Select parameter is set to one
(1) or Y
ES , a Select command must be received from the Client before an
execute command from the Client will be processed.
This section takes the following parameters:
 Point #
 DB Address
 Monitor Point #
 Monitor DB Address
 Require Select
ProSoft Technology, Inc. Page 97 of 201
March 4, 2013