NXP Semiconductors LPC24XX UM10237 - Manual (Page 701)

UM10237_4 © NXP B.V. 2009. All rights reserved.
User manual Rev. 04 — 26 August 2009 701 of 792
NXP Semiconductors
UM10237
Chapter 31: LPC24XX On-chip bootloader for flashless parts
6. ISP commands
The following commands are accepted by the ISP command handler. Detailed status
codes are supported for each command. The command handler sends the return code
INVALID_COMMAND when an undefined command is received. Commands and return
codes are in ASCII format.
CMD_SUCCESS is sent by ISP command handler only when received ISP command has
been completely executed and the new ISP command can be given by the host.
Exceptions from this rule are "Set Baud Rate", "Write to RAM", "Read Memory", and "Go"
commands.
6.1 Unlock <Unlock code>
6.2 Set Baud Rate <Baud Rate> <stop bit>
Table 630. ISP command summary
ISP Command Usage Described in
Unlock U <Unlock Code> Table 31–631
Set Baud Rate B <Baud Rate> <stop bit> Table 31–632
Echo A <setting> Table 31–634
Write to RAM W <start address> <number of bytes> Table 31–635
Read Memory R <address> <number of bytes> Table 31–636
Go G <address> <Mode> Table 31–637
Read Part ID J Table 31–638
Read Boot code version K Table 31–640
Compare M <address1> <address2> <number of bytes> Table 31–641
Table 631. ISP Unlock command
Command U
Input Unlock code: 23130
10
Return Code CMD_SUCCESS |
INVALID_CODE |
PARAM_ERROR
Description This command is used to unlock the Go command.
Example "U 23130<CR><LF>" unlocks the Go command.
Table 632. ISP Set Baud Rate command
Command B
Input Baud Rate: 9600 | 19200 | 38400 | 57600 | 115200 | 230400
Stop bit: 1 | 2