GE Industrial Solutions CPS6000-M2 - Manual (Page 129)

CPS6000-M2 Installation Guide H5694720
Issue 8 January 2008 129
Navigating Once Connected
Once you've connected to the controller, you should see the following screen. Note that any
alarms currently on the plant will be visible.
There are three pull-down menus you may choose to gain access to plant features and functions.
They are Configure, Control, and Status.
Configure
This pull-down menu allows one to access all Millennium II controller parameters that may be
uniquely configured. It allows access to set alarm thresholds and alarm relays, set battery connect
and disconnect thresholds, enable auto-boost mode and set boost charge thresholds, change
passwords, enable imminent shutdown feature, set rectifier parameters, configure serial ports, and
configure slope thermal compensation.
Control
This pull-down menu allows one to access all controller parameters that may be activated to
perform a function. It allows one to perform a plant battery test, clear all clearable alarms,
perform a lamp test, change the plant state from float to boost mode, and inhibit or restart
rectifiers.
Status
This pull-down menu allows one to obtain the status of the battery management system, i.e.,
battery current, battery temperature, number of VT-Probes and ES771A Voltage Imbalance
Detection modules are present. It also allows rectifier management, i.e., provides information as
to the number of rectifiers present and their output current.
Exiting
To exit the program, either hit the Disconnect icon or hit File and Exit.