Installing qs-series rectifiers – GE Industrial Solutions CPS6000-M2 User Manual
Page 44
Advertising
CPS6000-M2 Installation Guide H5694720
Issue 8 January 2008
44
Installing QS-Series Rectifiers
Action
Rectifiers are installed or removed with the rectifier handle in the open position as shown.
Use the above rectifier installation procedure as needed in the following steps:
Step
Action
1
Turn on ac service circuit breakers to apply power to the system rectifier positions.
2
Install a rectifier in an available rectifier position.
3
Wait until the rectifier establishes communications with the controller (the red Fail
LED stops flashing).
4
Verify green Norm LED is lit.
Advertising