GE Industrial Solutions CPS6000-M2 - Manual (Page 69)

CPS6000-M2 Installation Guide H5694720
Issue 8 January 2008 69
View Rectifier Current: Menu→ Status→ Rectifiers→ Rectifier Currents
This command is used to view rectifier currents.
View IP Address: Menu→ Status→ Network Settings→ (Port #)→ IP Address
This command is used to view the controller’s network IP address.
Restart Rectifiers: Menu → Control / Operations → Restart Rectifiers
This command is used to restart rectifiers.
This is a non-invasive procedure: rectifiers and converters that are operating normally ignore this
command.
Alarm History: Menu → History → Alarm History
This command is used to view alarm history.
History Alarm History
Rectifier History
Status
Alarm Thresholds
Rectifiers
Rectifier
Currents
Status Rectifiers
Network Settings IP Address Port 1 or 2
Control / Start Lamp Test
Restart Devices
Clear Events
Restart
Rectifiers