GE Industrial Solutions CPS6000-M2 User Manual
Page 50
CPS6000-M2 Installation Guide H5694720
Issue 8 January 2008
50
Network (LAN) Connections
Step
Action
Note
The LAN port P2 is an IEEE 802.3 compliant 10/100Base-T Ethernet interface.
This port can be used for remote monitoring or configured as local Craft port.
Factory default is to be a DHCP client where the network will serve the controller
and IP address.
Since the cable length required to connect to the network is variable, this cable must
be supplied by the user.
1
At the controller, connect one end of the network interface cable to P2. This
connector is located at the bottom center of the MCR1 board, and immediately
below the MCR2 board.
2
Connect the other end to an IEEE 802.3 compatible network.
3
Configure the network parameters by contacting the customer’s network
administrator.
BSL Alarm Outputs and Control Inputs
The following tables provide the input/output signal assignments for the BSL alarm interface
board. Use 18-26 gage wire for alarm board terminations. Form-C Alarm contact ratings are
60VDC, 0.3A