GE Industrial Solutions CPS6000-M2 - Manual (Page 49)

CPS6000-M2 Installation Guide H5694720
Issue 8 January 2008 49
The MCR1/MCR1B control board contains the connections for all the input and outputs. The
following table provides a list of the connections with their respective reference designators and
brief description of the particular connection.
Interface
Reference Description
P1 Connectorized interface for large parallel format 8x40 LCD assembly
P2 10/100 Base-T LAN/Ethernet interface
P3 Connectorized interface for 10K/30K thermistor probe options or 210E
P6 Connectorized input for input power, monitoring of two shunts, plant sense voltage,
and Major Fuse alarm (Same connection as on the Millennium)
P7 RJ45 receptacle for ground referenced Auxiliary RS485 circuit and One-Wire
monitoring devices
P8 BSL1-4 circuit pack Interface connector for Input/Output to controller
P9 RJ45 receptacle for isolated RS485 system component monitoring and control of
rectifiers, converters, low voltage disconnect contactors, and bay level alarm inputs
(Serial Rectifier bus)
P13 Factory test connector (not used in the field)
P14 Connectorized interface for future smaller serial format LCD
P15 Connectorized interface for future smaller serial format LCD
P201 Connectorized interface for optional Modem
P202 Ground referenced DB-9 for local RS232 serial port
P205 Option board connector
TB1 Terminal block interface for RS232/RS485 Auxiliary port and Remote Peripheral
Module (RPM) connections
TB2 Terminal block interface for three additional 10K thermistor probe or 210E connection
options
J10 USB interface (reserved for future use)
Fuses
Two Fuses, located on the MCR1/MCR1B board, provide protection for the controller input
power and Alarm Battery Supply (ABS). ABS is used to power alarm panels or other devices
requiring the power system voltage at no more than 1.3A.
Fuse Description Fuse Size
F1 Controller Input Power 3A
F2 Alarm Battery Supply (ABS) 1.3A