GE Industrial Solutions CPS6000-M2 - Manual (Page 47)

CPS6000-M2 Installation Guide H5694720
Issue 8 January 2008 47
Step Action
3
• Locate connector on rear of
ringer module and the mating
connector on the inside rear of
the ringer chassis.
• Align the ringer module
connector with the ringer
chassis connector. Place the
ringer module in the guides
and slide the ringer in until it
fully engages with the
connector at the back of the
ringer chassis.
• Note: The Ringer modules
install facing opposite
directions
• Repeat until all Ringer
modules are installed.
4
• Use Tip Jumper J12 to set the Ringer output type.
• Note: Ringer output type is determined by connecting Ring Return (Tip) to Battery or
Ground. External connection of Ring Return (TIP) to Battery or Ground may be used
with J12 in EXTERNAL position. Ringer output is disabled if Ring Return is not
connected to Battery or to ground.
Ringing Type
Tip Jumper
J12 Position
Comments
Ground Backed 1. TIP BAT
Battery Backed 2. TIP GND
Ground Backed – no-dc 2. TIP GND
Also requires Controller
configuration of dc Offset: Disabled
Externally Selected 3. EXTERNAL
Requires external connection of Tip
to Battery or Ground.
Repeat until all Ringer modules are installed