Teledyne LeCroy SAS Verification Test Descriptions - Manual (Page 104)

The University of New Hampshire
InterOperability Laboratory
Serial Attached SCSI Consortium
103 SAS Link and Transport Layer Test Suite v0.13
Test 7.2.2 - Connections – 2 SOAF Received
Purpose: To determine that the DUT properly handles received 2 SOAF primitives.
References:
7.2.5.11 SAS Standard
Resource Requirements: SAS Protocol Analyzer and Generator
Revision History: February 15, 2005
Test Setup: The DUT and the Testing Station are physically connected.
Test Procedure (Expanders):
• The Testing Station should start and complete a Phy Reset sequence followed by an Identify sequence
with the DUT. Since the DUT is a expander the Testing Station should transmit an Identify Address
frame indicating that it is an SMP Initiator.
• The Testing Station should transmit the following to the DUT
o SOAF primitive
o the first 4 dwords of an SMP OpenAddress frame
o complete SMP Open Address frame starting with SOAF.
• Wait for the DUT to transmit OPEN_ACCEPT and RRDY.
Observable Results:
•
Verify that the DUT responded to the received, complete Open Address frame with OPEN_ACCEPT.