Teledyne LeCroy SAS Verification Test Descriptions - Manual (Page 111)

The University of New Hampshire
InterOperability Laboratory
Serial Attached SCSI Consortium
110 SAS Link and Transport Layer Test Suite v0.13
Test 7.5.5.3 - BREAK – OpenTimeout Timer STP Target
Purpose: To determine that the DUT, an STP Target transmits BREAK after the OpenTimeout Timer expires.
References:
7.12.2.1, 7.12.6 SAS Standard
Resource Requirements: SAS Protocol Analyzer and Generator, SATA Device Port
Revision History: September 13, 2004
Test Setup: The DUT and the Testing Station are physically connected. The DUT is also connected to a SATA
Device Port.
Test Procedure (STP Target):
• The Testing Station should start and complete a Phy Reset sequence and an Identify sequence with the
DUT. The Testing Station should indicate that it is an Edge Expander in the Identify sequence.
• The Testing Station should simulate an SMP Initiator attached to the Edge Expander and open an SMP
Connection to the DUT an transmit a REPORT_GENERAL SMP Request. The Testing Station should
transmit a REPORT_GENERAL SMP Response.
• The Testing Station should open an SMP Connection to the DUT and transmit a DISCOVER SMP
Request to the DUT Phy which is attached to the SATA Device Port. The Testing Station should
transmit a DISCOVER SMP Response with this information.
• The Testing Station should open an STP Connection to the DUT for the attached SATA Device Port
and transmit an IDENTIFY DEVICE command, then close the connection.
• The Testing Station should wait for the DUT to transmit an OpenAddress frame for an STP
connection. The Testing Station should not respond to the OpenAddress frame with OPEN_ACCEPT
or OPEN_REJECT.
Observable Results: Verify that 1msec after transmitting the OpenAddress frame, the DUT transmitted BREAK.