Teledyne LeCroy SAS Verification Test Descriptions - Manual (Page 62)

The University of New Hampshire
InterOperability Laboratory
Serial Attached SCSI Consortium
61 SAS Link and Transport Layer Test Suite v0.13
Test 10.1.7 - SCSI CDB – WRITE(10)
Purpose: To determine that the DUT, an SSP Target port, properly handles a WRITE(10) command.
References:
SBC-2 5.27
Resource Requirements: SAS Protocol Analyzer and Generator.
Revision History: September 28, 2004
Test Setup: The DUT and the Testing Station are physically connected.
Test Procedure (SSP Target):
• The Testing Station should start and complete a Phy Reset sequence followed by an Identify sequence
with the DUT. Since the DUT is a target the Testing Station should transmit an Identify Address frame
indicating that it is a SAS Initiator.
• The Testing Station should open an SSP connection to the DUT and transmit a SCSI WRITE
command for 2048 bytes. Close the connection
• Allow the DUT to open an SSP connection to the Testing Station and transmit XFER_RDY.
• The Testing Station should open a connection to the DUT and transmit 4 512 byte DATA frames.
Close the connection.
• Allow the DUT to open an SSP connection and transmit a SCSI RESPONSE frame to the received
command and data.
Observable Results: Verify that the DUT transmits RESPONSE frame indicating that the command completed
with GOOD status. Verify that the DUT transmitted ACK for every received DATA frame.