Teledyne LeCroy SAS Verification Test Descriptions User Manual
Page 122
The University of New Hampshire
InterOperability Laboratory
Serial Attached SCSI Consortium
121
SAS Link and Transport Layer Test Suite v0.13
Test 7.5.9.2 - SMP_REQUEST – CLOSE
Purpose: To determine that the DUT, a SAS Expander, properly closes an SMP Connection.
References:
7.18.3 SAS Standard
Resource Requirements: SAS Protocol Analyzer and Generator. SAS Target.
Revision History: September 21, 2004
Test Setup: The DUT and the Testing Station are physically connected.
Test Procedure (SAS Expander):
• The Testing Station should start and complete a Phy Reset sequence followed by an Identify sequence
with the DUT. Since the DUT is an expander with an attached target the Testing Station should
transmit an Identify Address frame indicating that it is an SMP Initiator.
• The Testing Station should open an SMP Connection to the DUT and transmit a REPORT_GENERAL
SMP Request. The DUT should transmit a REPORT_GENERAL SMP Response.
• The Testing Station should transmit CLOSE.
Observable Results: Verify that the DUT transmits a CLOSE(NORMAL) after receiving CLOSE from the Testing
Station.