Canon imageCLASS MF7470 - Manual (Page 310)

1
2
3
4
5
6
7
8
9
10
11
9-5
Previous Back Next
TOP
Before Using the
Machine
Original and Paper
Copying
Sending and
Receiving
Printing and
Scanning
Network (imageCLASS
MF7480/MF7470 Only)
Remote UI (imageCLASS
MF7480/MF7470 Only)
System Settings
Maintenance
Troubleshooting
Appendix
Index
Table of Contents
Do not dampen the cloth too much, as this may damage the original
or break the machine.
Manual Feeder Cleaning
If your originals have black streaks or appear dirty after scanning
them through the feeder, this may be caused by pencil writing
rubbing off the originals and onto the roller. Perform this feeder
cleaning procedures to clean the feeder scanning area, film, and
rollers.
When cleaning the machine, first turn off the main power switch, and
disconnect the power cord. Failure to observe these steps may result in a
fire or electrical shock.
Do not dampen the cloth too much, as this may damage the original or
break the machine.
If the feeder scanning area is dirty, it may result in a paper jam or
blemished print output.
Spin the rollers while cleaning them. –
–
1. Open the feeder cover.
2. Clean the rollers (a total of three places) inside
the feeder cover with a cloth dampened with
water. Then wipe the area with a soft, dry cloth.