Canon imageCLASS MF7470 - Manual (Page 82)

1
2
3
4
5
6
7
8
9
10
11
3-11
Previous Back Next
TOP
Before Using the
Machine
Original and Paper
Copying
Sending and
Receiving
Printing and
Scanning
Network (imageCLASS
MF7480/MF7470 Only)
Remote UI (imageCLASS
MF7480/MF7470 Only)
System Settings
Maintenance
Troubleshooting
Appendix
Index
Table of Contents
Place the originals horizontally in the following cases:
If you are enlarging LTR originals to 11" x 17"
If you are enlarging STMT originals to 11" x 17"
Placing an original horizontally means setting the original with the
longer side sideways.
If you are reducing 11" x 17" originals to LTR with Auto Orientation in
Copy Settings (from the Additional Functions screen) set to [Off ], load
LTRR paper into a paper drawer or the stack bypass.
1. Press (COPY).
2. Place your originals.
3. Press [Copy Ratio].
4.
To reduce the original image, select a preset
reduction ratio. To enlarge the original image,
select a preset enlargement ratio. Following
your selection, press [Done].
5. Select the paper size.
If you set [Auto] for [Paper Select], the machine selects the paper
best suitable to the selected ratio.
If you copy highly transparent originals, such as transparencies,
the correct paper size may not be selected.
6.
Press (Start).
To return the copy ratio to 100%, press [Direct].
To cancel all settings and return the machine to the Standard
mode, press (Reset).
–
–
–
–
–
–
–
–
–
Zoom by Percentage
You can reduce or enlarge images by any copy ratio, in 1%
increments. The available copy ratios are from 50% to 200%. The
same copy ratio is used for the horizontal (X) and vertical (Y) axes.
1. Press (COPY).
2. Place your originals.
3.
Press [Copy Ratio].
4. Press [-] or [+] to set a copy ratio, then press
[Done].
You can also use – (numeric keys) to enter values, and (Clear)
to clear your entries.
You can change the value by pressing [-] or [+], even if you have
entered the value using
– (numeric keys).
If you enter a value outside the setting range, a message prompting
you to enter an appropriate value appears on the screen.
5. Select the paper size.
If you set [Auto] for [Paper Select], the machine selects the paper
best suitable to the selected ratio.
If you copy highly transparent originals, such as transparencies,
the correct paper size may not be selected. –
–