Rockwell Automation 1407-CGCM Combination Generator Control Module - Manual (Page 31)

Rockwell Automation Publication 1407-UM001G-EN-P - April 2013 31
Installation Chapter 2
Fault Relay Output
The fault relay output is an open-collector sinking output. The fault relay output
terminals are on TB4 and are labeled FLT. The following illustration shows a
typical connection.
Figure 18 - Typical Fault Relay Connection
Redundancy Relay Output
The redundancy relay output is an open-collector sinking output. The
redundancy relay output terminals are on TB4 and are labeled RD RLY. The
following figures illustrate typical redundancy connections.
Figure 19 - Typical Redundancy Voltage Sensing Connection Diagram
TB 6
VBus A
VBus B
VBus C
VBus N
TB6
VBus A
VBus B
VBus C
VBus N
Bus Voltage
Connections
TB5
V Gen A
V Gen B
V Gen C
V Gen N
TB 5
VGen A
VGen B
VGen C
VGen N
CGCM 1
CGCM 2
Generator
Voltage
Connections