Rockwell Automation 1407-CGCM Combination Generator Control Module - Manual (Page 73)

Rockwell Automation Publication 1407-UM001G-EN-P - April 2013 73
CGCM Unit Configuration Chapter 4
2. Select 1407-CGCM and then enter the Major Revision of the host
firmware (for example 4 where the host firmware revision is 4.
x or 2 where
the host firmware is revision 2. x).
3. Click OK.
The Module Properties dialog box appears.
4. Enter a Name for the module, its ControlNet Node address, and its
Revision (the minor revision number, for example 2 where the host
firmware revision is 3.2).
5. Select an Electronic Keying mode to suit your application needs and click
Finish.
IMPORTANT
You must enter the correct Major Revision at this time. Do not change the
Major Revision number once the module is created. If you need to change
it at a later time, you must delete the module and configure a new
module.
TIP
Alternately, you can click Next to begin configuring the CGCM unit at this
point. Refer to the configuration tabs description below.