RIGOL DP832A - Manual (Page 110)

RIGOL Chapter 2 Command System
2-86 DP800 Programming Guide
[:SOURce[<n>]]:CURRent:PROTection:CLEar
Syntax [:SOURce[<n>]]:CURRent:PROTection:CLEar
Description Clear the circuit and label of the OCP occurred on the specified channel and turn on
the output of the corresponding channel.
Parameter Name Type Range Default
[<n>] Integer 1|2|3 1
Explanation  You can send the [:SOURce[<n>]]:CURRent:PROTection:TRIPped? command
to query whether OCP occurred on the specified channel.
 Before executing the command, make sure that the reason that causes the
OCP on the specified channel is cleared (you can decrease the output current
to be below the OCP value or increase the OCP value to be greater than the
output current); otherwise, the command is invalid. Executing this command
will clear the circuit and label of the OCP occurred on the specified channel and
turn on the output of the corresponding channel.
 When [:SOURce[<n>]] or [<n>] is omitted, the system clears the circuit and
label of the OCP occurred on the current channel.
 You can send the :OUTPut:OCP:CLEAR command to only clear the label of the
OCP occurred on the specified channel.
Example :CURR:PROT:TRIP? /*Query whether OCP occurred on the current channel
and the query returns YES*/
(Operation: decrease the output current to be below the OCP value or increase the
OCP value to be greater than the output current)
:CURR:PROT:CLE /*Clear the circuit and label of the OCP occurred on the
current channel*/
:CURR:PROT:TRIP? /*Query whether OCP occurred on the current channel
and the query returns NO*/
Related
Commands
:OUTPut:OCP:CLEAR
[:SOURce[<n>]]:CURRent:PROTection:TRIPped?